Ubiquity U6+/Lite Single Gang Box Mount/Faceplate

prusaprinters

This is a remix of Kai's Octagon Box Mount merged with hadigar's U6 Lite replacement mounting plate. Simplifies CamS' solution into a single printed item (no additional screw required). The standoffs for the octagon box have been removed and the mounting surface to the box is shifted down/away from where the AP installs so it sits flat onto the face, similar to an actual faceplate.  The two screw holes are sized for screws that typically come with faceplates. Space for the wire to come out of the box and into the AP remains when mounted. Recommend to pass the cable through opposite of where the connector is located once installed (see image).Material: Any (I used ABS)Layer height: 0.2mm RecommendedInfill: 15% RecommendedSupports: Required. I used organic (Tree) supports that broke off easily.