Ubiquiti Nanobeam M5 external mount replacement

thingiverse

External mount replacement for a Ubiquiti Nanobeam M5. Meant to replace the stock mount which comes with the device. You may need supports on the arm, specifically where the holes intersects the ball. Your software's automatic supports should be sufficient. I suggest printing the arm upside down (as pictured) for best results. You can also print it sideways by putting it about 1mm above the bed and using supports. The coupler should print in place without supports. I printed these in ABS for the higher heat tolerance and better outdoor / environment ruggedness, but they should print in PLA as well. Check the settings I used and adjust as necessary. Update: There is now a version of the mount arm which conforms to a mounting pole, as in the original design.