uBench - My tiny customizable benchmark

thingiverse

I created this tiny benchmark because I wanted to tune my settings and do quick iterations on different config values. This model only takes a few minutes to print and uses ~1g of filament so I was able to print dozens of it quickly. Benchmark features - The base is 10 mm wide, 4 mm high, and bridge_length + 5 mm long - The base has two wedges that should barely touch on the bottom to help detect elephant's foot - The markings on the side (bar height and bridge length) show the vertical detail accuracy and help detect ghosting - The embedded cone has a defined clearance and helps to optimize tolerances - The two poles show stringing problems and problems with z-wobble - The bridge helps to optimize bridging and cooling settings