Tyco RC Twin Turbo Lamborghini Conversion Kit

thingiverse

Full size servo and ESC switch mount kit to convert your 1987 Tyco 9.6v Twin Turbo Lamborghini. This is mainly non destructive. You can remove your original board and servo intact to keep in case you can fix it later. Uses all the original screws and motors. I used a HobbyWing QuickRun 880 Brushed motor ESC, JR 537 full size servo, a Spektrum 2.4Ghz receiver, 2S LiPo pack. You need to print 2 of the servo mounts and 1 switch mount. Instructions: -Snip the motor power wires. Snip the antenna cable and leave the antenna in place. -Unscrew and remove the original board and servo. -Plug the servo mount towers over the original screw mounts and screw them down. -The servo mounting holes point to the front. -Screw in your servo from the front. -Make up new tie rods from steel wire (get at any hobby shop). -Screw on the switch mount and double stick the switch in place (watch the on/off direction). -Put bullet connectors on your cut motor wires and plug them in to the ESC. -Bind your receiver and trim it out.