tx526 + r9mm tpu version - martian 2

thingiverse

I've built an inav phoenix reborn from old quad components, basically an experiment that turned out to fly pretty well so I decided to optimize it a bit for the long range. It's designed specifically for the martian2 special edition frame with a 7 inch long range quad setup. The light version is optimized for tpu prints and requires supports to print properly. The lower bay has space for several components, including: - An r9mm antenna positioned optimally so it's visible to the tx from almost any angle - Two 11mm diameter capacitors - A 10mm buzzer - Space for an r9mm rx module - Four led holders in the back using a ws2812b smd led board from geekcreit Also, print this at a slow speed of around 20 - 25 mm/sec. Cheers. Update: - I've increased the space for rgb leds to avoid any tight spaces. - I've added vertical position options. - Check out this other vertical holder you might like: https://www.thingiverse.com/thing:3843419 Make one!