TX03 Mount for Eachine Micro Skyhunter

thingiverse

This is a custom TX03 Camera mount tailored specifically for the Eachine Micro Skyhunter.\r\n\r\nNot yet thoroughly tested; however, designed to securely screw into pre-drilled 20mm separated holes on the canopy section. The holes on the mount are engineered to accommodate M2 (2mm) self-tapping screws that will firmly affix to the FPV canopy, and can accept screws with heads up to 6mm in diameter, including flanged heads as well.\r\n\r\nAdditionally, a flat front and gradient edge were added to the camera base to enable support-less printing. The back edges were rounded off for both aesthetic appeal and weight reduction purposes.\r\n\r\nThe zip-tie gap under the camera was retained (enlarged due to slightly oversized ties), as it is planned to loosely ziptie the camera to the mount as a backup measure. To ensure extra security, the mount will be screwed into place on the plane, with hot glue applied for added stability (note: these cameras often generate excessive heat that can compromise the effectiveness of using hotglue alone).\r\n\r\nThe print settings used were 3 wall thickness, 1.2mm top and bottom layer heights, 100% infill density, resulting in a remarkably light yet strong structure when printed with PLA material.