TX02 95mm Racing Frame (1103 motors) F.Version

thingiverse

What's new in this final version: * Holes for battery strap - Four pillars for better camera mount durability - In-built arm reinforcement - Easy-to-install Flight controller - more space for outlets, battery connector, micro USB ------------------------------------------------------------------------------------------------------------- Original camera mount: https://www.thingiverse.com/thing:1954514 - 95-100mm Frame - Weight: under 16g (Printed with 60% infill) - Using 1103/1104 motors - 20x20mm flight controllers: Four-millimeter holes for screws - FPV Camera - TX02/RX01 + hole for buzzer's pins behind camera mount - BE CAREFUL when sliding the camera into holder. Sliding it with too much pressure can break some electronic parts in the back of your TX01/02. My TX02 stopped working after sliding, so I had to solder a 0.15mm condenser back in place. Glue everything together using second glue (if necessary). For added reinforcement, use tape and some weight to press it down. * TIP: After reinforcement is printed, keep the printer's hotbed cool, or it may bend and not fit well on the frame. * I used: KingKong 1103 motors * 20x20mm FC with 10A ESCs * Gemfan 2035 * Eachine TX02 If you print one, please let me know! On the finish, just a note: frames made of PLA are very fragile. Use ABS or buy carbon fiber ten times stronger.