TwoPlus - Fusor Module - Chinese Jhead Support

thingiverse

Soporte for Chinese clones of the Jhead minimalista and sensor LJC12A3-H-Z/BX (1-5mm) without using nuts. Designed to be used with TwoPlus (http://www.thingiverse.com/thing:1828399), although there should be no problem adapting it to any other system. For optimal operation, the Jhead Chinese heat sink must be drilled apart to allow a 4mm Teflon tube to pass through from side to side so that the Teflon tube is in contact with and sits on top of the barrel end. Print Settings Printer: Prusa i3 Supports: Yes Notes: The support must be used compulsorily. It is preferable to use high layers. Post-Printing Requirements The hole for the passage of the M5 socket head screws that block the extruder are designed to be machined over with an M5 socket head screw. Everything except for the screws blocking the fusor should enter smoothly, it can be forced but if something enters hard it should be calibrated before heating up the head and damaging anything. The sensor must enter very smoothly, if it gets stuck at any point it must be reworked with a file and by hand since the rework should be minimal. The sensor gets blocked in its position with a plastic clip relatively strong (3.5mm and beyond) on the lower end to lock the sensor's threads with the marks of the printed layers. Custom Section Warning This support will mark the Jhead fusor we use because it was designed for GRIPEN nuts on aluminum. I have never had any problem, I have been using this system for a long time but it is said.