Twonky's Nightmare Single Tiles

thingiverse

Worked out a suggestion by cjohnson44546 to detach the tiles, each now printable separately with a groove at the bottom for fitting into the grid. The grid is a 3x3 square and can be extended using connector pieces. In addition to this basic grid, I plan to add taller ones, so boards with ramps are also possible, though this has not yet been done. Note: setting up the game board may take some time now. Print Settings Supports No Custom Section Instructions Select the tiles you want in the grid. Print them (no support needed). Left out the pits, which come naturally when a tile is left unfilled in the grid. Then print 1 or more grids. No support needed. Print connectors to connect the grids. Connectors work as a separate row for tiles. The corner connectors sit in the middle of four grids. The edge connectors are used on the edges between two grids. The normal connectors are used between two grids.