Two Part Dragon Creme Egg Holder

thingiverse

# CRUCIAL! ***NOT AN INCH OF LATITUDE IS ALLOWED HERE*** This is a straightforward chop + alignment tab with 0 tolerance built right in. I printed the base .5mm smaller and it fit perfectly, but you could also print and trim/sand/file depending on how precise your printer is. ## **Description** I printed the amazing [Dragon Creme Egg Holder](https://www.thingiverse.com/thing:3543155) but couldn't get all the supports out cleanly and some I just couldn't pull out at all (under tail and belly). I cut the model so that I could get the supports out without damaging the base, and it also has the added benefit of being able to use different materials for dragon and base. ## **Directions** Print both halves, scaling one (or both) for tolerances, do any post processing, shove the dragon on the base and use your favorite glue to hold it together (or rely on friction). The dragon requires supports.