Twisty Vase

thingiverse

This is my second design to hit the printer, and it's already a significant improvement over the first attempt that didn't quite make the cut for publication. Unfortunately, this one still falls short of holding water due to its relatively low infill percentage of 30%. As shown in the third photo, you can see why increasing the infill would be necessary to achieve the desired level of watertightness. I created this vase using an app on my iPad called Polygonify, which I highly recommend for its ease of use and versatility. To get the best results from this design, I suggest rotating it 90 degrees and scaling it up or down as needed. Print Settings: Printer: Flash Forge Creator Pro Rafts: Doesn't Matter Supports: No Resolution: 0.2 Infill: 30 Notes: You're awesome indeed!