TwipTwaks

thingiverse

These trackers are 13.4mm thick(62x50) about the size of a belt buckle. The goal was to make SlimeVR trackers that both where very small and comfortable with long battery life (7-10hrs depending on cells) and the ability to swap the bats out on the fly to keep playing. these support 40mm straps and can be used with smaller ones. all components are the same from original slimes minus the charge controller and lipo. we are adding these: * .2mm copper sheet * .4-.45mm pen springs * Rechargeable AAA batteries (1100mah) * AAA charger Batteries that where tested are EBL 1100mah and can be found on amazon for fairly cheap. there is a solid copper strip that is inserted in the rear of the case before closing that should have a slight curve to it. this is used as the AAA contact pad inside. and 2 longer 4.5mm wide strips for + and - terminals that feed through the case, these should be bent inwards on the inside of the case during assembly. the - terminal is the outside most and the + is inner most for both sides. it is very important not to get the bats inserted backwards. the lids insert that is included uses sprints to make contact on all points. do not insert the spring lid without batteries inserted. this will cause the contacts to get stuck. this can be made out of any material that is stiff enough for the strap loops and has good layer adhesion. a good PLA plus, PC, Nylon, are good options. a BRIM must be used on the cap insert, is optional on the main case. try to avoid brim on the cap and end cap. NO SUPPORTS needed to print this whole model. just print orientated how its shown in the pictures provided.