Twin headshell box

thingiverse

So here it is, a remix of the nice headshell case. The design was completely remade in Fusion360 so now I can make any changes on it quickly. It's outer dimensions remain the same, inside I made these changes: - Lowered the shell holders by 3.5mm - Shortened them by 2mm so it's easier to insert longer shells - Increased the distance between them by 1mm - Changed the retaining blocks in the upper lid, made them lower and a bit wider to follow the changes made on the shell holders - The cut under the latch was unnecessarily large, made it smaller (smaller through-print effect on the outer side as well!) - Changed the pattern on the upper lid where one opens the case - Applied fillet to all inside edges (some were missing in the original design) and changed to 1mm instead of 2mm which looked too much for me - Incorporated a little holder for a 45rpm puck - Under one of the holders I integrated a 52mm overhang gauge (for Technics players) I think that's all. The hinge has the same dimensions and tolerances as the original design, so it should print without issues. Now that I have the box model, I can go for the next version: box for my T4P cartridges! Stay tuned!