Tweaked Photo Sweep Stand

thingiverse

The comments at http://www.thingiverse.com/thing:106568 list a few issues with that version, which I also experienced when printing one myself, so I imported it into OpenSCAD, using the original files that you can download to use the OpenSCAD source included with this thing, and produced this new version. I replaced the printed pin with 1.75mm filament, added some ribs to hold paper tightly, and removed a thin feathered edge at the bottom that wouldn't print well. To build: Print the 3 STL files and enlarge the holes using a small drill bit so they can fit 1.75mm filament through them. Glue 1.75mm filament to each washer on both ends. Then, run one end of the filament through the holes in the platen and the stands and glue it to the stand, letting the platen spin freely but stay in place from side to side. Next, clip the platen down between the stand and run the paper through to hold it firmly in place with small ribs grabbing on the paper so it won't slip around.