TUSH2 - A simple sliding re-remix

prusaprinters

<p>I just receive the MMU2S (my journey is starting… I know) so I need to adapt my workspace.</p><p>I love this sliding remix of the TUSH2 (<a href="https://www.thingiverse.com/thing:2853619">here</a>) and I used it as my main spool holder for all my print but some detail were bothering me so I corrected them:</p><ul><li><strong>3mm nuts</strong> are now <strong>placed inside</strong> the spool, rather than popping outside. So you can pack spools side by side satisfyingly.</li><li><strong>3mm nuts</strong> were not hold in position properly in the original version, now it is a satisfying <strong>very tight fit</strong> (use a clamp). Nuts will never turn again.</li><li>Now, If you use a <strong>3mm bolt</strong> of <strong>length 12mm, </strong>It will not stick out of the TUSH2, as it was [slightly] the case in the previous version.</li><li>The <strong>sliding rail</strong> length has been <strong>increase to 24cm </strong>and supported with 3 small screws. This change was important to me: MMU2S = 5 spools. You can print many of them on the prusa bed at once.</li><li>Sliding rail t<strong>olerance has been increase</strong>, should be easier to slide.</li><li>I <strong>dropped the arms</strong> support system, going back to a plain design without any hole.I never used them in my previous versions.</li></ul><p>THIS IS A REMIX FROM A THINGIVERSE MODEL: <a href="https://www.thingiverse.com/thing:2853619">https://www.thingiverse.com/thing:2853619</a> I could not reference it properly in the prusaprinter system as it has not been imported here yet.</p><p>&nbsp;</p><p>Edit: 01/04/2022:</p><p>It was suggested in the comments/makes to reduce the scale of the Rail to 95% to allow better slide with no resistance. According to what you want, i.e. tight slide or easy slide, you might want to follow that advice. Thanks !</p>