Turtlebot3 Mount for the Raspberry Pi Camera Module (V1.3)

thingiverse

This camera module mount fits in between two supports for the Turtlebot3 from ROBOTIS. With this mount, the Raspberry Pi Camera Module can be attached to the Turtlebot3. If you order the default camera with the default ribbon cable, it will just about fit (not much more play on the cable). Print laying down on the back side (camera mount points sticking up). As to prevent warping, I printed using brims, but this might not be necessary on your setup. Print at 50% infill to make sure the points of the mount are strong enough. Thank you to the original designer on which this remake is based, it saved me a lot of time designing my own mount. My camera is mounted with some tie-wraps, but of course you could also use some (hot) glue.