Turnout for OS-Railway - fully 3D-printable railway system!

thingiverse

This is the exact same turnout that's been featured on our main page. I decided to move it over here to keep things easy to follow. Main Track Page: https://www.thingiverse.com/thing:2146361 Check out this video for step-by-step building instructions. Quick Tips: Material: PLA Layer Height: 0.2mm Support: Only for swinging track parts (printed upside down) Hardware Needed: None - no screws or extra tools required, except for your own tools. Print the Swinging Track Assembly STLs, but only use the ones that end in 1 or 2 if you need to print an extra copy of any individual part alone. Note! This isn't mentioned in the video, but if your train keeps derailing when running on the turning section of this turnout, it might be due to the gap where the two different rails intersect being too narrow. To fix this, try increasing the gap by cutting away a bit of the straight track - start with one millimeter at a time until your train can pass without derailing.