Turnigy Fabrikator Bed height adjustment knob

thingiverse

Turnigy Fabrikator Bed Height Adjustment Knob This is a direct replacement for the Z height adjustment knob on the back of your printer. I replaced my original knob with this one because it had some unwanted play and I needed finer control over setting the minimum Z height, allowing me to achieve more precise results. This new knob fits perfectly in place of the one shown. I printed it using PLA and it worked flawlessly and fit snugly. To ensure a smooth fit, you may need to drill out the center hole slightly to accommodate the bolt easily. Installation To install this replacement knob on your printer, start by unbolt the existing knob using a 7mm socket. Remove the existing knob from the back of the printer and carefully insert the new version. Reattach the knob by reconnecting the existing bolt and nut. Tighten it just snugly and then recalibrate your bed using Autohome as instructed in the manual. Post-Printing Do you have any further questions or would you like to share more about your experience?