Turnigy 9XR Multi-Protocol Module Case

thingiverse

A custom housing for the DIY 4-in-1 multi-protocol module allows the use of Turnigy 9XR Pro's internal antenna.\nTo utilize this enclosure, you may need to modify your multi-protocol module - I had to remove the 5-pin header connector from its original position on top of the board and re-solder it underneath. This was done to ensure a good connection with the module bay pins.\nSince I use my module in serial mode, I also removed the bind button so that I could have a completely flush cover plate.\nYou will need an MCX to IPX/U.FL antenna cable, like this: http://www.ebay.co.uk/itm/262040276984\nIn fact, 15cm is slightly too long, but the extra coax can be easily looped under the board. 7.5-10cm would probably be better.\nI'm still tweaking and fine-tuning, but the parts are essentially functional at this point.\nUpdate:\nI've published a version for the newer STM32 board: https://www.thingiverse.com/thing:2788944\nPrinting Settings\nPrinter: Anet A8\nRafts: No\nSupports: No\nResolution: 0.1\nInfill: 25%\nNotes: I printed the antenna connector cap and guide at 0.1 as they need to be fairly precise. The case and cover can be printed at 0.1 or 0.2, as you prefer.\nThe antenna connector guide needs to be glued in place on the underside of the enclosure.