Turn Signal Stem Set - 2002 Kawasaki VN1500 and Others

cults3d

All four turn signals on my 2002 Kawasaki VN1500 Vulcan Classic Fi were in a sorry state - you can see one of them in the photos. I know from previous experience that replacements for these are in the $50 a piece price range, believe me! I'll do some rigging to save $200! For some reason, you can't even buy just the stems themselves, even though the turn signals are designed to be disassembled into its individual components. That made designing replacements a lot easier. I thought I was going to have to design a complete assembly, but once I took one apart, I found that wasn't the case. These are designed specifically for the Vulcan, but I'm sure these will fit a wide variety of bikes. The stems on the front signals are 50mm long, while the rear stems are 80mm long. In my design, the threaded pipe not only serves as a pass-through for the wires but also aids in adding stability to the stem. To assemble these, you'll need, from the original turn signal: the lamp socket (and obviously the lamp itself) the rubber grommet on the wires the clip the reflector the lens (including the gasket and the screws) the head You'll also need to purchase: 1/8" IP brass plated lamp nipple - you'll need 65mm for each stem 1/8" IP brass nut for each stem 3/16" stainless steel washer for each stem To disassemble the original turn signal, follow these steps: Remove the screws securing the lens and remove the lens. Remove the lamp. Remove the reflector. Pull the clip up away from the lamp socket and the old stem. Cut the wires, remembering to leave enough outside the stem to work with later. Pull the lamp socket out of the stem. Remove the stem from the head - push or pull in whichever direction is easier in your case. For assembly: Press the guide pin in the hole on the bottom of the stem, using cement if necessary. Cut a 65mm length of lamp nipple. It helps to have two nuts on the section you cut so you can work those back and forth to restore the threads after you make the cuts. Thread 50mm of the nipple up into the stem, using the cement of your choice to secure it as you go. Insert the stem into the head. Threading the wires back through the stem, press the lamp socket into the stem from inside the head. Press the clip around the stem, securing both it and the lamp socket into place. If the clip is a bit loose, you can bend the legs slightly to increase tension. Reassemble the lamp, gasket, and lamp. Reinsert the wires and stem into the mount, being sure to thread the wires through a washer and a nut, tightening the nut on the stem to secure the whole assembly to the mount. Resolder the wires back to the original harness, using splices if necessary. Pop the top on your favorite beer, rev your motor, and head out on the highway!