Turin / Morph DM47 magnetic base plate

thingiverse

Magnetic base plate for the dosing cup on Turin DM47 and similar rebrands (Morph, etc). The stock cup isn't magnetic and tends to slide around the base if or prone to getting knocked over. I slide the cup on and off instead of pulling it off the base. If you are using a weaker adhesive, the pull action will rip the magnet off your base.Parts:1x 20x1mm neodymium magnets1x 20x2mm magnet or 1 to 2x 20x1mm magnets (depending on hold)Thin VHB Tape or Adhesive to attach the magnetic to the cupThick VHB tape for baseInstallation notes:Attach single 20x1mm magnet to the recessed portion of the bottom of the cup. Critical that you use a very thin VHB tape or glue to attach the magnet to the bottom of the recessed portion of the dosing cup. A thick tape will make the magnet stick out and not allow the cup to sit flat. Use either a single 20x2mm magnet, or stack one to two 20x1mm and slide it in to the recessed base. Place tape over it so it stays (see image). I added a bit of clearance for the tape to sit flush. You can adjust the magnet hold depending on the adhesive method you are using.