Turbo Timber Evolution Carry handle

thingiverse

This carrier allows you to remove the wings and spar from your Turbo Timber Evolution and carry them with the fuselage more conveniently by keeping everything together and adding a carry handle. It *may* fit other Eflite Timber versions, but it has only been tested with the Turbo Timber Evolution. It attaches to the fuselage in the same manner as the wings do normally, and the wings can be slipped in on either side, and the spar can be slipped in to the hanger as well. Print both front and rear sections in your chosen material (PLA works fine) and add a length of 1" diameter stock about 7.75" long for the handle (I used some 1" stainless tubing I had, but wooden dowel should work fine also). Print settings should be pretty open, but I believe I used 3 perimeters and 20% infill.