Tupolev Design Bureau

prusaprinters

<p>I was browsing the internet, looking at logos of old aircraft manufactures and wanted to see if I could recreate some of them. The finished print is approximately 100mm(3.75 inches) wide and 90mm(3.5 inches) tall.&nbsp;</p><p><strong>Print instructions:</strong></p><p>This can be printed easily without the MMU2 since the color changes occurs at a specific layer. I printed it in PETG, but PLA would work just fine too.</p><p>Parameters that I used were .15 layer height, 15% infill, 5 solid layers top/bottom and ironing on all top surfaces.</p><p>Just add a color change in Prusa Slicer where the print transitions from the blue base to the white details.</p>