Tulip vase

thingiverse

I created a 3D-printable model of an old Dutch "Delfts blauw" tulip vase because I wanted one, but they were too pricey, so I decided to make my own! I divided it into two parts so it should fit on most printers (mine is a Wanhao i3).\nMake sure you seal it tightly after printing. Mine was slowly "sweating" water over time.\nPrint Settings\nPrinter: \n My printer is the Wanhao duplicator i3\n \n Rafts: \n I didn't use rafts\n \n Supports: \n I didn't use supports\n \n Resolution: \n .2mm resolution worked well\n \n Infill: \n 20 percent infill saved me time, but mine wasn't completely watertight, maybe using 100 percent infill is better.\nRemember to rotate them so they're right side up. Solid Works and Cura disagree about which way is up.