Tube pipe straightening tool 16mm v2

thingiverse

Straightening Tool for Tube with 16mm Diameter V2 This is my tube straightening tool version 2, which I tested solely with multilayer plastic tubes. It's specifically designed for 16mm diameter tube pipes. I used this version for a renovation DIY project: over 150 meters of perfectly straightened tube were achieved. To print the tool, you need to print it three times using *Straightener_face_v2.stl*. To assemble and use the tool, you'll require: * Twelve ball bearings, model 608ZZ (8 x 22 x 7mm), available on Amazon. * Twelve M8 nuts, twelve M8 bolts with a length of 30mm, and twelve M8 washers. I've also made my FreeCAD project available for the design of **Straightener_face_v2.stl**, and I welcome any advice. The improvements in this version 2 include: * A funnel was added at both entry and exit points. * The diameter can now be adjusted to 15mm. * Easier printing: a flat side has been added. * Reduced filament usage: it's now divided by more than two times.