Tub Drain Removal Tool for 38mm Opening

thingiverse

I had to swap out a drain because the shield on my original one kept shifting and falling off. I discovered that the tool created by JNADS was too large for my drain, so I modified it slightly to make it smaller (down to 38mm) and reduced the openings at the bottom to be slightly smaller than the diameter of the tool.\r\n\r\nI also had a 30mm 1/2" drive socket available, which is what I used as the hex at the top to remove and install the drain.\r\n\r\nIt worked well and I'm sharing this in case someone else has a similar drain as mine.\r\n\r\nI printed my version using PETG with the same settings (5 perimeters and top/bottom) that JNADS used.