TTGO T-Display case

thingiverse

More to be added, display clips into a holder (surround.stl) that offers protection and insulation on its own, the slide then slides into either close_slide which completely encapsulates the device or one with full access to headers and battery terminals can use open_slide. Both slides have easy access to front buttons that are just proud of the front, reset button is accessible but will need a toothpick or slide back out of the case and can be reached with a finger. Will be adding further options for batteries, stands, and various modules (18650, BME280, and data logger next). T-display_with_headers is the rough model I created for designing around, just uploaded it to see if STL preview is functioning yet. Edit: added mount slide which is a slightly more solid front panel intended to have different backs attached, first back is ext_case_small_slot which has a 14mm wide slot to leave ribbon cable hanging out or hot melt a connector into. Mount slide and the backs have a 2mm hole all the way through intended to poke some filament to hold them together, just using one side makes it a hinge. 2mm holes in the sides and ends of the back are also for filament that can string through and hold a PCB in place or mount assorted add-ons yet to be designed. Reset button is still a work in progress, again filament can make an adjustable length pin for the reset button, I melted the end and mushroomed it over where it hits the button.