
TTGO T-Beam Lora32 v1.1 0.96" OLED Vertical enclosure
thingiverse
A redesign from a great project that allows to hold and operate the device vertically with a 0.96inch OLED. It's a tight fit and you need to remove the pins of the OLED as well slimming down the adhesive of it - it might need a little readjustment too but will then stay in place. When putting it together slide in the board first, then the OLED carefully. Make sure get use some electrical tape on the OLED backside to avoid any shorts. There are 2 version of the housing, one to hold the original GPS antenna (6x16mm) which performed poorly. I replaced it with a better 15x15mm module from Adafruit which works much better: https://www.adafruit.com/product/2461 I also shorted the reset button as I kept pressing it way too often by accident. Added a reinforced lanyard holes to the bottom of the 15x15mm GPS housing.
With this file you will be able to print TTGO T-Beam Lora32 v1.1 0.96" OLED Vertical enclosure with your 3D printer. Click on the button and save the file on your computer to work, edit or customize your design. You can also find more 3D designs for printers on TTGO T-Beam Lora32 v1.1 0.96" OLED Vertical enclosure.