TS80 Case remix 3 tips

thingiverse

TS80 Case remixed from thing 3440265 by jacobgad. I modified it so that it holds an extra tip in the soldering iron. There are now three tips available for the TS80, so they can all fit in this remixed version. I like that I don't have to keep pulling the tips in and out of the soldering iron to store it as I typically use the same one very often. This means that the case is longer though because of that. *** NOTE: The magnet size is changed from original thing *** Changes from the original: - Longer to add an extra tip to be left in the soldering iron - Changed magnet size to 3x6mm (Those are the magnets I have) - Offset the magnets so that the lid magnets stick out about 1mm, so that it helps lock the lid in place. The lid magnets stick out 1mm. The top of the base magnets get inset into the base by 1mm. - Removed some area in the center to give your fingers space to grab the tips and soldering iron - Reduced width to make it narrower - Cosmetic change to the chamfer in the middle, so that it is only in the front - Cosmetic change to add chamfer to the very top and bottom of the case. I couldn't get the back top to chamfer properly, so I left it without a chamfer. It could make the hinges weaker, so I think it works out and still looks okay. Hardware: 2x M3x30mm countersunk screws 4x 3mmx6mm Neodymium Magnets (** Changed from jacobgad's original thing **) See original thing for more info... https://www.thingiverse.com/thing:3440265 A big thanks to jacobgad for the original design. Nice work! 2020-01-17 - V5 version because I included the lid twice on accident. Thanks for noticing 77TickTock. 2020-01-05 - Increased length of tip areas by 1mm to give a little more room for the newer wedge tip when it has solder on it. The newer wedge tip is a little longer than the previous tips that were released. 2019-12-09 - Initial release