TS100 Stand Form

prusaprinters

<p>This is a form to bend a 2.5-3mm wire into a coil as a stand for a ts100 or similar soldering iron. I used a cloths hanger, but sanded the paint off first so the hot iron wouldn't burn it.</p> <p>After forming the end can be cut with a hacksaw to make unscrewing it easier. The offset top makes it harder to unscrew without deforming. You could try cutting it apart before unscrewing. I may post a two piece design if there are any requests.</p> <h3>Print Settings</h3> <p><strong>Rafts:</strong></p> <p>Doesn't Matter</p> <p class="detail-setting supports"><strong>Supports: </strong> <div><p>No</p></div> <p><strong>Resolution:</strong></p> <p>2.8</p> <p class="detail-setting infill"><strong>Infill: </strong> <div><p>30</p></div> <p><strong>Notes:</strong></p> <p>at least 3 perimeters and 30% infill to make it stiff enough. I used PLA, but anything should work.</p> </p></p> Category: Electronics