TS100 mount - Adafruit heat insert press

thingiverse

This is a mount for the ts100 soldering iron for the adafruit heat set insert press.(I've yet to fully assemble everything, but I've test fitted the clamp with my ts100, will update)You'll need two M3 (i used m3x5, of the type thats ~4mm in diameter) heat set inserts pressed on the back side of the clamp, then you can use 2 M3x12 screws to mount the clamp to the arm.I recommend you also use an M2x8 screw so you can use the grounding screw to secure the iron into the clamp.The clamp is quite a snug fit and in my case holds the iron in place without a screw (still used it because I don't want a 250C iron falling out), and you might have to adjust your print settings if your's doesn't fit. The USB port is also slightly covered to prevent the iron from sliding out the top of the clamp.The arm has the clamp hole size reduced to fit just an M3 screw, so you can put the heat set inserts into the clamp rather than into the arm.I also added the CAD files if you want to make any adjustments to them.Thanks to Marcell for the ts100 model: https://grabcad.com/library/miniware-ts100-soldering-iron-1The heat insert tip that I use with my ts100: https://cnckitchen.store/products/ts100-101-adapter-tips-set-m2-x-m3-m4-m5-m6-1-4-m8-100-lead-and-cadmium-free