TRX6 Hauler extensions - No Filler Panels

cults3d

UPDATE: Another file has been added - Extensions V2 which has a small slight taper on the end hole and the top ridge has been raised by 1mm for a tighter fit to the end rails. I decided to offer up just the extensions for those that do not have access to a larger 3d printer. These extensions can be printed 1 at a time on the smallest of 3d printers. you will need to make your own filler panels to fill the void. these will increase the width to @11.5" wide. Will require 12 3mmx50mm countersunk machine treaded screws. To assemble, remove the factory deck panel, carefully cut all of the led zip ties, then unclip the led's from the factory side caps. then remove the side caps. Install the extensions and install the side panels using the 50mm screws. then reinsert the leds and add new zip ties where needed. You may need to reroute some leds to make them reach but soldering in new wires should not be needed.