True Y motor stabilizer for Anycubic Chiron

thingiverse

Hi, Here is a real Y stabilizer for the Y motor of the Anycubic Chiron. This fixing prevents rotation and deformation of the engine. For me, this modification was important, and I wanted to make a model much more efficient than what exists. It only requires 4 screws and 2 nuts. This attachment is mounted on the rear of the engine. It's a real fixation. I decide to upload it for everyone. I assume that the gap of the engine steel support is the same for everyone, this gap is important for the correct fixation of my part. This system is not a fake and works. It completely avoids motor rotation. The only weakness remains the micro rotation of the V-slot 2020, but I don't print at high speed. I have faithfully reproduced the dimensions of the engine, and the system is based on the gap between the steel support and the 2020 V-slot. Observe the correct fit of the part before screwing. My system does not collide with the underside of the bed. But check, it should be slightly set back from the endstop. I did not notice an increase in the transmission of vibrations and sound from the motor in the aluminum structures, but I suppose it may be the case depending on the stepper motors and jerk. See miscs for assembly. I hope it will be good for you, make, test, throw away or enjoy !