Trout Spoon/ Blinker Press

thingiverse

This press is for 1mm Stainless steel sheet. I recommend 2mm top and bottom thickness, and at least 1.5mm thick walls with 50% infill. After Cutting the blank from the steel you can sandwitch into the Press part, with a little bit of WD40. Be careful, that it sits centered, and that both press halves are correctly oriented to each other. You just press it in a bench vise, a hammer could work aswell if you are carefull. When its finished, you can drill the holes of approximately 2mm in to both ends. Afterwards, you can paint it if you want. The final Spoon weights about 3.5 grams.