Trouser Clip for hangers

prusaprinters

This is a really simple clip to keep your trousers in position on a hanger, to stop them sliding and forming creases or falling off. It is especially useful for suit trousers that are quite thin and not very stiff. Printing instructions:Print lying flat with 5-20% infill for best results. They take about 45 mins each.I would recommend increasing the perimeters to 3 or 4 layers. Version 2 (10/1/24) This model has been updated in several ways:It has tabs to be easier to pull off the hanger without snappingIt has two diameters of holes, allowing it to be used on typical wooden hangers or typical wire hangersIt provides more grip on the trousers, while being more flexible due to the second circular spring addedIt provides more grip to the trousers by using a textured inner surface