Trophy Base for 1" x 3" Plate, 2 versions (With STEP file)

prusaprinters

Update 12/14/2019: The TrophyBase-with-plate7E1 STL and STEP files were updated with version TrophyBase-with-plate7E2b. The only change is a small chamfer on the support inside the base which may help with keeping the center support from shifting during printing. The resolution of the STL has also been increased from the prior version. Update 2/4/2019: I found that the "TrophyBase-with-plate7D3.stl" had an unnecessary void which would not have been visible but would have caused a longer print time. I removed that file and it has been updated with the new version "TrophyBase-with-plate7E1.stl" which fixes the problem. This is a trophy base designed for a 1"x3" plate (with rounded corners), which I have yet to receive. I am leaving this as a work in progress until I get the plate to test, but the dimensions appear correct on the printed model. The pic shows a lower resolution version of what I have uploaded here (I did not realize I was printing a low res version until it was too late). The model on top is Rick Sanchez (RickFinalSized.stl) which can be found at the link below. The trophy base should work with non-Rick models as well, though I have not tested any so far (update - confirmed, it does work). https://www.thingiverse.com/thing:2465552 I also uploaded versions without the plate (both STP and STL files). Jan 14, 2019 - Updated the 2nd version (TrophyBase-with-plate7D3.stl) with a higher resolution STL which should smooth out the curves a bit. The STEP file is included for that as well. All the files here should now be the higher res versions. Print Settings Notes: Please orient this for printing, it needs to be rotated so the base is flat on the build surface. I printed at 0.2mm with supports only touching the build plate. Category: Sculptures