TronXY X5SA PRO Low-Rider Direct Drive Mount (Original by Icer32)

thingiverse

Edit: V2 included for genuine Titan extruder. The original design needed to have the motor offset by 3mm in depth and 1mm horizontally. A simple remix of the low-rider mount made by Icer32. This requires the top part that connects to the chain guide to be removed by a cutting tool (recommended) or via several small holes and careful bending (not recommended). I have added rear bracing to the original design, as well as added more holes to match the four available in the front. Then from there, I mirrored the design so that it goes across the entire carriage. Holes can be drilled into the other side of the carriage assembly for longer screws to pass through both sides. This is to prevent the extruder mount from bending towards/away from the extruder when retracting, as well as to provide additional bracing for the carriage assembly as a whole. Added a little cable stay as well for the side.