Tronxy X5SA PRO + BMG Aero/Wind

thingiverse

This is for a Direct Drive conversion. Mellow BMG Aero/Wind (Right hand) Extruder and Pancake Stepper to be mounted on a Tronxy X5SA/T/Pro. I couldn't Find a Mount that suited my needs for printing at higher speeds of 120mm/s+ so i made one and it has been working quite well. i designed this in TinkerCad. I primarily used parts from the two remixes below with a few additions of my own. The Mount is already in the correct orientation. Support is required, I Used "touching Build plate" in Cura. none of the holes need support. The ABL mount will fit the Stock Tronxy Sensor or a BL Touch. Any Heater block will work with this mount (Volcano as well.) the design is set for a right hand extruder (mirror in slicer if you have the left hand version. I Used a 23mm Stepper motor but 20mm will work as well. Ive been printing with this mount for about a week at 120mm/s and its been producing great results. if you print this please post and let me know. I'd love feedback on improvements I can make. Also, Thanks to the creators of the two things that I used for this remix. Z Probe Offset: X=80 mm Y = 12 Hardware needed 4 M3x12 Cap head or Flat head screws (3 Mount, 1 ABL) 2 M3 nuts (ABL sensor) 2 screws that are currently on your ABL sensor (M3 I think) 1 M3x20 (5015 Fan) 1 5015 Fan (dual ball bearing recommended) 1 4010 Fan (reuse stock extruder fan and screws) 1 Mellow BMG Wind/Aero (right) (mirror in Slicer for Left) 1 Pancake Stepper Motor (20-24mm)