Tronxy X5SA Bed Chain Bracket

thingiverse

Design based upon mounting bracket provided by Tronxy on the SD card shipped with the X5SA. I had mismounted the junction box and snaped the original bracket in two the very first time I homed the printer. I also lost the little metal bracket in between the time I broke the bracket and when I finished printing the new one. What to do? I took out my trusty 3D modeling software and rotated a copy of the original bracket, then cut off the excess bracket below. I think it would look better in black, but all I had left was white PLA. Printing: I used 10% infill cubic, no supports, raft with air gap, 215 degrees hot end, 50 degrees bed to print this using Cura 4.11 Cost to print: about 19g and 2 hours