Tronxy X5S / X5ST Smoothieware config.txt for MKS Sbase with bltouch

thingiverse

**UPDATE: I strongly advise against using Smoothieware. After a lengthy period of usage, I can confidently say that it's a major letdown. Marlin 2.0 is where it's at. I'll leave this here for reference and the thrill-seekers in the 3D printing community who enjoy pushing their luck. This is a Smoothieware config.txt file tailored specifically for the Tronxy X5-S and X5-ST, paired with a MKS Sbase V1.3 board and BLTouch sensor. To mount the BLTouch, I recommend using a Petsfang dual duct cooler with BLTouch mount to avoid having to adjust offset values. Check out this handy guide: https://www.thingiverse.com/thing:2984806 Based on the brilliant work of SgaboLab and drucktipps3d.de, I've modified this config to suit my needs regarding speeds and features. The MKS-Sbase is available on banggood, along with the MKS TFT, which works seamlessly without any configuration required. https://www.banggood.com/custlink/m3KDYBTNCe To initiate bed-leveling before printing, use the following gcode sequence: M280S3 lowers the BLTouch probe G32 performs calibration M280S7 raises the BLTouch probe If you plan to utilize the Ethernet port of the MKS SBase, ensure that you input an IP address compatible with your network at the end of the config file (default is 192.168.178.78). I highly recommend updating Smoothieware to its latest version before use, which can be found on github: https://github.com/Smoothieware/Smoothieware/tree/edge/FirmwareBin Key Features: - Supports cooling and heatsink fans - Virtual thermoswitch for controlling heatsink fans - BLTouch bed-leveling - 7x7 bed calibration points BLtouch Wiring: Probe-Out,5V,GND -> ZMax Endstop connector Servo-In -> P1.23 (pinheader in top-left corner) General Wiring: Most connections are self-explanatory Connect cooling fan to FAN terminal Connect heatsink fan to HEATER2 terminal You'll need an adaptor to connect your z-motors in series, as Smoothieware doesn't support dual-z configuration Set microstepping jumper (top-right corner) to 32 microsteps MKS-TFT (optional) to AUX1 IDC header Remarks: If the extruder spins in the wrong direction, remove the ! in line 81 Filament runout sensor coming soon