TRonxy X5S X & Y motor mounts

thingiverse

After receiving my Tronxy X5S, I noticed that the X and Y motor mounts were prone to flexing. In response, I designed these custom mounts to eliminate that flex. They will need additional support since I left a section under the 2020 rail without bracing. If desired, it's possible to remove this support as well. Update 11/7/17: I've revised the design to better meet my initial requirements. If you've previously downloaded an earlier version, I recommend deleting it and printing these new mounts instead, which will not require supports and offer a sturdier structure than the factory part. Update 11/18/17: Despite being printed for over a month, I finally had time to install these custom mounts. Unfortunately, the front lower bolt hole doesn't align properly due to my oversight of the rail offset. I'll attempt to rectify this issue shortly and upload an updated file.