TronXY X5S & SA bed-support System

cults3d

14.06.2019: V2.1 Found and corrected some dimentional issues i had overseen on the main part in V2. 09.06.2019: V2 Totally redesigned from the bottom up, This is made for 8mm Drylin bearings so the bearing holes are 15.97mm, this is to pre-tention the bearings so they get tight and eliminate as much play as posible. Borrowed the modular lowering block idea from Spegelius with 5mm and 10mm lowering blocks. The support itself will lower the bed 13mm. I will leave the old versions up, the new parts will have "V2" in the end. I also included a little tool to remove the bearings, since the Drylin's are pressfit. Really liked DKDaigle's design, but it makes us running belt synced Z-axes loose closer to 50mm of Z-travel due to the Z-stabilizer not being able to go past the Z-coupler and drivegear. This will also make those of you without belt-sync gain back some Z-travel by going past your Z-couplers. Choose the one best suited for you! The standalone lower piece is meant for those who's already printed the original (ONLY for the 8mm rail version) and want to regain some Z-height. Just neatly cut away the two original parts from each stabilizer and glue in the standalone piece. The other's are for those who haven't printed the original or simonvez's remix yet. One "standard", "simonvez's" remixes with 10mm added lowering for 8mm rails, 10mm lowering for 12mm rails and one "standard" with 12mm rails. Original thing: https://www.thingiverse.com/thing:3096759 simonvez's initial remix: https://www.thingiverse.com/thing:3129736