Tronxy X5s Pulley Spacer

thingiverse

I designed a spacer quickly in Fusion 360 to install actual pulleys on my Tronxy X5s. You will need to print 14 of these spacers total, I printed 20 so that I had a few extras since they are small. Pulleys I purchased as replacements for the poor design that came stock. I bought two packs each. https://www.amazon.com/gp/product/B078SF12YS/ref=oh_aui_detailpage_o09_s00?ie=UTF8&psc=1 https://www.amazon.com/gp/product/B01H3DNKYY/ref=oh_aui_detailpage_o09_s00?ie=UTF8&psc=1 You can tighten these down quite a bit, but be careful because I managed to break two sending them flying across the room in pieces. Tighten until some resistance is felt on the bearing, but no angular movement in the bolt should be felt.