TronXY X5S Mount - E3D V6/Lite6/Volcano

thingiverse

Custom Mount for TronXY X5s to Support Any E3D Hotend with V6 Mount. This bracket features integrated fan ducting, allowing you to easily screw in the E3D hotend fan into its designated spot on the front. The stock TronXY part cooling fan mounts are located on the right side, while the endstop mounts can be found on the left (you may need nuts to secure them properly). Note that part cooling fan mounting is specifically designed for the volcano hotend. If you're using a V6 or Lite6 hotend instead, the fan will likely be too low and cause interference. To accommodate these models, you'll need to move the two mounting holes on Part B upwards, allowing you to use the stock fan assembly without issues. The first part prints as is. To print Part B, rotate it so that the "3D" logo faces upwards, then enable supports. Make sure to remove all support material from the model after printing, ensuring a clean surface for clamping around the hotend.