Tronxy X5S Marlin 1.1.9

thingiverse

The original display functions correctly, the selection knob operates smoothly by rotating clockwise to access the menu (enable REVERSE_MENU_DIRECTION if you want the original feel). AutoTemp is disabled but Filament Change is enabled under the Tune menu. Filament Change procedure Configuration_adv.h: PAUSE_PARK_RETRACT_LENGTH 6 // Initial retract of 2(mm) before pausing. Avoiding blob formation. FILAMENT_CHANGE_UNLOAD_LENGTH 850 The filament should stop a few centimeters short of exiting the feeder, depending on the length of the tube. FILAMENT_CHANGE_FAST_LOAD_LENGTH 800 New filament is fed quickly near the nozzle. ADVANCED_PAUSE_PURGE_FEEDRATE 3 Remaining feed is done slowly to clean the nozzle. ADVANCED_PAUSE_PURGE_LENGTH 100 Increase this value if extrusion doesn't come out clean. Press button for faster printing. ----- NOTE: Compile with Arduino 1.8.5 only!! Sketch uses 129196 bytes (99%) of program storage space, maximum is 130048 bytes. (Arduino 1.8.7 consumes 130064 bytes and won't fit)