TronXY X5S Bed Support Upgrade

thingiverse

I recently acquired a TronXY X5S. This printer has required numerous upgrades to get it up and running smoothly, and I can honestly say it's gone from being a nightmare to an absolute dream. One of the biggest issues I had with this printer was related to the bed. The steel frame that supports the bed on my printer is extremely warped, which made it very difficult to set up. I've installed a E3D V6 with Auto Bed Level Proximity sensor on the Standard Melzi Board. After going through all these upgrades, I noticed that my bed still rocked from side to side and found that 2 of the plastic bearing guides were cracked. Instead of just buying new ones, I decided to design something different that would support the bed better. My original plan was to print 8 of these new supports and place them above and below the bed. But after placing just 4 under the bed, I achieved the improvement I was looking for. I hope this helps someone else who's struggling with a similar issue!