Tronxy X3 Supercooler - hot end fan shrouds

cults3d

UPDATE: Check out my new Mitten Cooler design that just dropped. It should work great and all you'll need is a 5015 fan. My stock Tronxy X3 printer's hot end could only hit 205ºC. The stock design was cooling the heater block way too much, so I needed a solution to print higher temp >220ºC filaments. That's why I came up with this. It reuses the screws from the hot end radiator, but you'll need to remove the washers first. It's designed for left and right 30x30x10mm fans (12v), but one fan will do if that's all you've got. If you add the left one, though, you'll need my custom x stop. Custom x Endstop: http://www.thingiverse.com/thing:1906501 Wire those 30mm fans in parallel and I added a y-connector for good measure. If this helps, I'd appreciate a tip - at least give it a like and show me your prints! Assembly video: https://www.youtube.com/watch?v=aMM67JGe3qQ Just so you know, this won't work with the auto leveling sensor. If enough people ask, though, I might figure out something to make it compatible.