TronXY X1 Spool Holder (Print without support)

thingiverse

I've scoured Thingiverse high and low for a reliable spool holder that would fit my Tronxy X1, but every design I tried was a dud. One bent, another refused to cooperate with its mounting points... so I took matters into my own hands and designed one from scratch. This custom spool holder prints in record time thanks to its partially hollowed-out structure, yet it's still robust enough to hold a full 1kg spool without buckling under the weight. No pesky support material needed here! To get started: 1) Print out both the spool holder and the end cap. 2) Swap out the original handle on your Tronxy X1 for this new spool holder, using the two short screws that held it in place originally. 3) Load up a fresh spool onto the spool holder. 4) Secure it all with the end cap. Now you're good to go!