TronXY X1 Dual/Single 40mm Fan Mount and Part Coolers and Cable Router

thingiverse

Here's a redesigned part cooler made from scratch by me, tailored specifically for the TronXY X1. It's a significant upgrade over many part coolers I've seen and used here. Complex designs may look impressive on paper, but they often fall short in practice, especially when tiny 40mm fans are pushing only 0.0001m^3 /s of air through them. These fan ducts employ a straightforward geometry that has been extensively tested to minimize induced friction and deliver the maximum amount of unobstructed, even airflow. This cooler is designed for simplicity, allowing it to function seamlessly with either one or two fans - the most common setup used by most people. Using two fans produces the best results, and the rotation of parts doesn't matter when slicing. To make this possible, I quickly created a Y-splitter that works perfectly in conjunction with the Tronxy Mainboard, enabling it to run both fans simultaneously without any issues. The images included showcase a before-and-after comparison (grey before, white after) of using the fans and the most popular ring fan mount found on this platform. This will give you a clear understanding of just how effective this redesign is. Additionally, I've included a cable router that may not be essential but is highly recommended to extend the lifespan of your printer's cables. You can use it in conjunction with or without the heatsink fan and side fans for optimal results.