Tronxy D01 E3D V6 hotend adapter

thingiverse

Adapter to be able to replace the default Tronxy D01 (corexy style) hotend with a E3D V6, V5 should also work. I had to cut a little bit out of the original metal casing ( the one with the fan ) but other than that I did not have to modify anything else ! Stock bed/ stock endstops, stock software, stock fans Finally i was able top get rid of that ugly default PETG stringing that might have been caused by the default extruder. ( pretty sure that was it, since now it`s massively reduced ) You only need 2 screws to fix it in place on the carriage, the holes go over the metal thingies that the old extruder was fixed in place, slide them inside, put 2 small 3mm screws, used some short leftovers ( no idea the length), tighten them, and then for the cap you can use any screw that is longer then the cap, the holes go all the way to the back of the carriage, they have a modeled ... to screw into. Print them with the holes up. no supports needed